Sealand ECO vent filter Bedienungsanleitung PDF herunterladen (Seite 3)

2 General safety instructions

The manufacturer will not be held liable for claims for damage resulting from the following:

• Faulty assembly or connection

• Damage to the unit from mechanical inuences

• Alterations to the unit without express written permission from the manufacturer

• Use for purposes other than those described in the operating manual

3 Intended use

When a toilet is ushed on a boat with a holding tank, air is pushed out of the holding tank, through

a vent hose, and out of the boat through a vent tting. To stop foul-smelling air from coming out of

the vent tting, install an ECO Vent Filter.

4 Installation

Remove old ﬁlter (if replacing existing vent lter)

1. Remove vent hose from both ends of old vent lter. If old vent lter was connected to threaded

ttings for 5/8-in./16 mm or 3/4-in./19 mm ID hose, those ttings should remain attached to vent

hose.

2. Remove old lter from bracket and seal ends with adhesive tape.

3. Discard old lter in appropriate container.

Install ﬁlter

NEW INSTALLATION

1. Select location for vent lter. Avoid areas near excessive heat sources (engine manifolds,

lights, etc.). Do not install lter below top of holding tank (g.

p. 2).

2. Vent lter can be mounted at any angle. Installations near thru-hull vent reduce chance of lter

damage from potential overlling of tank.

3. Install mounting bracket (g.

1, p. 2) with screws (g.

2, p. 2).

4. Lightly lubricate O-rings on each end of lter cartridge with Dometic Hose Lubricant or silicone

grease.

5. Remove red plugs from each end.

6. After vent hose ID is chosen, attach correct size hose adapters (g.

5b or 5c, p. 2) to lter

cartridge with retaining fasteners (g.

4, p. 2). Refer to Adapter Size Chart below to identify

correct size hose adapter.

7. Press ECO vent lter (g.

6, p. 2) into mounting bracket so that it clicks into bracket arms.

8. Route vent hose from waste holding tank and thru-hull tting to ECO vent lter. Using hose

clamps (not included), attach vent hoses to adapters that are connected to vent lter.

Ref. Description

4 Retaining fasteners

5a threaded adapters for 5/8-in. or

3/4-in. ID hose threaded ttings

5b 5/8-in.+3/4-in. ID hose adapters

5c 1-in.+1.5-in. ID hose adapters

Adapter Size Chart (g.

, p. 2)

ECO Vent Filter General safety instructions

Hose adapter

connection zones for:

5/8 in./16 mm ID hose

3/4 in./19 mm ID hose

1 in./25 mm ID hose

1.5 in./38 mm ID hose

1 2 3 4 5 6 7 8 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Sealand ECO vent filter Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Sealand ECO vent filter